The 'Edit Wire Point' button can be used to edit the properties of a catenary or auxiliary wire at a structure, add equipment to a structure, or edit any previously attached equipment.
Step 1: Navigate to the 'Wires' section of the Lineardraft toolbar
Step 2: Click the 'Edit Wire Point' button
Step 3: Click on the equipment or wire point you want to edit
This will open the 'Configure' window.
Step 4: Edit the wire or equipment to your requirements
There are more guided instructions on adding catenary equipment here, and adding auxiliary equipment here.
To make changes to previously attached equipment you can use the equipment editor. Learn more here.
Top tip: You can customise the wire support style parameters of your chosen wire support style by clicking the 'Customise' button. Find out more here.
Step 5: Click 'Confirm'
This will close the 'Configure' window and confirm your changes.
